Parkside battery to Ryobi tool adapter

In stock · Made-to-order resin · Ships from Auckland · Free shipping over $75

Material

High-Detail Resin (8K)

Colour

Grey

Weight

~40 g

Print time

~4.5 h

Shipping

$10 std · $20 express

Lead time

1-3 d print + 1-4 d ship

Parkside battery adapter for Ryobi tool.Mixed two pieces of work together, I admit that. Did some modifications so they fit together. You need to print: 1x top1x bottom2x clipAnd extra: 4x 6.3mm Faston male crimp connector, "blue" (accepts 1.5 - 2.5 mm2 cable) but without the plastic protective tubing2x ~10cm cable (I advise 2.5 mm2)CA glue or any "fast" glue1x some small spring (from a pen, split in half)a) 4x M3 screws4x metal M3 threaded inserts that you put in with heat (f.e. with soldering iron)you can also screw it in directlyb) or just glue it togehter :-) (but watch the alignment!)Put the cable through the holes, crimp or solder the connectors, glue them in place. If something is tight, help it with a little heat (soldering iron), but be careful. It should work 99% straight out of the printer. Connecting just the two connectors on each side (+ & -) works for the tool, but don't try to charge it with Ryobi charger. Charge the battery with Parkside charger only! Print SettingsPrinter Brand: Prusa Printer: i3 MK2S Rafts: No Supports: Yes Resolution: 0.2 Infill: 30 Filament: any PLA / PETG Notes: Top (tool part) and Clips can be printed without supports. Bottom (battery part) piece require supports. Origin - remix from: https://www.thingiverse.com/thing:1248463 https://www.thingiverse.com/thing:3649747 https://www.thingiverse.com/thing:3114131 Category: DIY