3D Photo Session (Event)
Put the booth in the room and scan your guests.
For corporate events, expos, birthdays and launches. We bring the rig to your venue and scan guests through the night, then print and ship each figurine afterwards. Priced per event on guest numbers and travel, so this one starts as an enquiry rather than a booking.
What it costs
| 1 person | $1,500 |
| 2 people | $1,500 |
| 4 people | $1,500 |
| Each extra person | +$79 |
How it goes
- Book a time. Pick a slot below and pay the deposit to hold it.
- Come in. 1 hr at the studio. Wear what you want to be wearing forever.
- We clean it up. A raw scan is never print-ready. This is the part that takes the skill.
- Collect it. Around two to three weeks later, longer for large pieces.
Questions
How many guests can you scan in an evening?
Roughly twenty to thirty an hour depending on group sizes, because the capture is quick and the queue is the limit rather than the rig. We print and ship each figurine afterwards.
How long until I get my figurine?
Two to three weeks from the session for most pieces, longer for large or multi-person prints. The scan itself takes minutes; the time goes into cleaning the mesh by hand, which is the part that decides whether it looks like you.
What should I wear to a 3D scan?
Texture and pattern scan beautifully. Avoid shiny black, sheer fabric and anything reflective, because the scanner reads those as holes. Bring a change if you are unsure and we will tell you which reads better before we start.
Where are you based?
Our studio is in Auckland. For events we bring the scanning rig to your venue anywhere in New Zealand.
Do I pay the whole amount up front?
No. $250 is taken when you book, to hold the slot. The balance is due when you collect the finished piece, because the final figure depends on how many people end up in the scan and how large the print is.